Saturday, January 28, 2017

BOLT PLATES FOR ARRAY 2 MICROPHONE

I had a Local Las Vegas Company ask if In-House Production could come up with a Custom Hanging Brackets for their ClearOne Beamforming Array 2 Microphones. They were looking for 1/2 inch space between the Array 2 Microphone and ceiling. The other criteria was to bolt the Microphone to the electrical receptacle box mounted on the ceiling or wall. I said, we at In-House Production are up to the challenge.
ClearOne Beamforming Microphone Array 2.

Beamforming Array 2 Microphone Double Bracket #92000
In-House Production came up with the Design, then Machined our Design form a block of 6061 T-6 Aluminum.
The Face Bracket attaches to the Array 2 Microphone. It also has 4


Pins for Sliding the 2 parts together. The second part of the Custom Machined Bracket is 6061 T6 Aluminum which attaches to the Electrical Receptacle Box on the ceiling or wall. What a simple idea for installing the Beamforming Array 2 Microphone.

The half that attaches to the Array 2 Microphone weights in at 1/2 pound and bolt right to the Microphone.

This part of the Bracket can bolt to the Microphone, or be re-drilled and be fitted to anything one might need to hang.

Bottom Bracket with Hook Pins. #92000A



You can check out the Photo and see that when the Bracket is attached to he Microphone, it has the hole in the middle and space under the bracket for Data Cables to run under without interference.



As you look at the Mounting Bracket you can see the 2 screws going into into the Electrical Receptacle Box and hold the upper bracket into place. With the added slots, the Microphone be placed at a 45 degree or 90 degree to the Electrical Receptacle Box. It also has a little play so the plate can move for the special touch.

Ceiling/ Top Mounting Bracket to except Hook Pins #92000B

We made a few extra Receptacle Mount ClearOne Beamforming Array 2 Microphone Hanging Brackets. If you have a need for this type of bracket, give us a call at In-House Production. Ask for 92000 is both together or 92000A is the bottom part or 92000B is the top part.

In-House Production. 6620 W Arby Ave. Las Vegas, NV 89118. tel 702-631-4748. info@ihplabor.com.





No comments: